Discharge rate consistency of each channel for UAV-based pneumatic granular fertilizer spreader

Xunwei Wang, Rui Jiang, Zhiyan Zhou, Cancan Song, Xiwen Luo, Ruifeng Bao, Zichen Lyu, Junhao Huang, Jianqin Lin

Abstract


Unmanned aerial vehicles (UAVs) are widely being used to spread granular fertilizer in China. Granular fertilizer spreaders equipped with UAVs are mainly centrifugal disc-type and pneumatic. The multichannel pneumatic granular fertilizer spreaders (MPGFSs) have a banded fertilizer deposition distribution pattern, which are more suitable for variable rate fertilization than the circular deposition distribution pattern of disc-type granular fertilizer spreaders (DGFSs). However, the existing MPGFS has the disadvantage of inconsistent discharge rate of each channel, which affects the uniformity of fertilization. In order to explore the causes of inconsistent discharge rate of each channel, the discrete element method (DEM) and bench test were performed to analysis the discharge process of the fluted roller fertilizing apparatus and distribution of fertilizer in axial direction of fluted roller. The computational fluid dynamics (CFD) was used to simulate the airflow field of pneumatic system to analyze the influence of airflow on the movement of fertilizer particles. The simulation results of the discharge process of the fluted roller fertilizing apparatus showed that the filling velocity at the axial ends of the fluted roller fertilizing apparatus was lower than that of the middle. The reason was that the filling capacity was weak near the wall. The simulated results of the airflow field without partitions showed that the airflow provided by the axial flow fan was rotational, and this caused the particles to move irregularly in the throat, resulting in inconsistency discharge rate of each channel. Based on the analysis of reasons of inconsistent discharge rate of each channel, a MPGFS with partitions in the throat was developed. The discharge rate bench tests were carried out to optimize the partition spacing parameters, and fertilization test was performed to test the performance of the improved MPGFS. The discharge rate test results showed better consistency with partition. The coefficient of variation (CV) of the discharge rate of each channel was 20.16% without the partition and 7.70% with the optimal partition. The fertilizer spreading uniformity test results shown that the CV of spreading uniformity of MPGFS without partitions was 15.32%, and that MPGFS with partitions was 8.69%. The partitions design was beneficial to improve the consistency of each channel discharge rate and the uniformity of fertilization. The finding can provide a strong reference to design the MPGFS.
Keywords: UAV, discharge rate, fertilizer spreader, DEM, CFD
DOI: 10.25165/j.ijabe.20231604.7129

Citation: Wang X W, Jiang R, Zhou Z Y, Song C C, Luo X W, Bao R F, et al. Discharge rate consistency of each channel for UAV-based pneumatic granular fertilizer spreader. Int J Agric & Biol Eng, 2023; 16(4): 20-28

Keywords


UAV, discharge rate, fertilizer spreader, DEM, CFD

Full Text:

PDF

References


Alameen A A, Al-Gaadi K A, Tola E. Development and performance evaluation of a control system for variable rate granular fertilizer application. Computers and Electronics in Agriculture, 2019; 160: 31-39. doi.org/10.1016/j.compag.2019.03.011

Qi X Y, Zhou Z Y, Lin S Y, Xu L. Design of fertilizer spraying device of pneumatic variable-rate fertilizer applicator for rice production. Transactions of the CSAM, 2018; 49(S1): 164-170. (in Chinese)

Shi Y Y, Chen M, Wang X C, Morice O O, Li C G, Ding W M. Design and experiment of variable-rate fertilizer spreader with centrifugal distribution cover for rice paddy surface fertilization. Transactions of the CSAM, 2018; 49(3): 86-93. (in Chinese)

Yang L W, Chen L S, Zhang J Y, Sun H, Liu H J, Li M Z. Test and analysis of uniformity of centrifugal disc spreading. Transactions of the CSAM, 2019; 50(S1): 108-114. (in Chinese)

Zhang C H, Kovacs J M. The application of small unmanned aerial systems for precision agriculture: A review. Precision Agriculture, 2012;13(6): 693-712. doi:10.1007/s11119-012-9274-5

Yang S L, Yang X B, Mo J Y. The application of unmanned aircraft systems to plant protection in China. Precision Agriculture, 2018; 19(2): 278-292. doi.org/10.1007/s11119-017-9516-7

Zhou Z Y, Ming R, Zang Y, He X G, Luo X W, Lan Y B. Development status and countermeasures of agricultural aviation in China. Transactions of the CSAE, 2017; 33(20): 1-13. (in Chinese)

Hassler S C, Baysal-Gurel F. Unmanned aircraft system (UAS) technology and applications in agriculture. Agronomy, 2019; 9(10): 618. doi: 10.3390/agronomy9100618

Wan J J, Qi L J, Zhang H, Lu Z A, Zhou J R. Research status and development trend of UAV broadcast sowing technology in China. An ASABE Meeting Presentation, 2021.doi:org/10.13031/aim.202100017

Li J Y, Lan Y B, Zhou Z Y, Zeng S, Huang C, Yao W X, et al. Design and test of operation parameters for rice air broadcasting by unmanned aerial vehicle. International Journal of Agricultural and Biological Engineering, 2016; 5: 24-32.

Wu Z J, Li M L, Lei X L, Wu Z Y, Jiang C K, Zhou L, et al. Simulation and parameter optimisation of a centrifugal rice seeding spreader for a UAV. Biosystems Engineering, 2020; 192: 275-293. doi:org/10.1016/j.bio systemseng.2020.02.004

Ren W J, Wu Z Y, Li M L, Lei X L, Zhu S L, Chen Y. Design and Experiment of UAV Fertilization Spreader System for Rice. Transactions of the Chinese Society for Agricultural Machinery, 2021; 52(3): 88-98.

Brazelton R W. Dry materials distribution by aircraft. Transactions of the ASAE, 1968; 11(5): 635-641.

Liu C H, Kang Q, Hu S R. Research on model test of aircraft spreader. Transactions of Journal of Jilin University, 1986; 4: 22-30. (in Chinese)

Bansal R K, Walker J T, Gardisser D R. Computer simulation of urea particle acceleration in an aerial spreader. Transactions of the ASAE, 1998; 41(4): 951-957.

Bansal R K, Walker J T, Gardisser D R, Grift T E. Validating FLUENT for the flow of granular materials in aerial spreaders. Transactions of the ASAE, 1998; 41(1): 29-35.

Bansal R K, Walker J T, Gardisser D R. Simulation studies of urea deposition pattern from an aerial spreader. Transactions of the ASAE, 1998; 41(3): 537-544.

Song C C, Zhou Z Y, Zang Y, Zhao L L, Yang W W, Luo X W, et al. Variable-rate control system for UAV-based granular fertilizer spreader. Computers and Electronics in Agriculture, 2021; 180: 105832. doi.org/10.1016/j.compag.2020.105832

Song C C, Zhou Z Y, Jiang R, Luo X W, He X G, Ming R. Design and parameter optimization of pneumatic rice sowing device for unmanned aerial vehicle. Transactions of the CSAE, 2018; 34(6): 80-88. (in Chinese)

Song C C, Zhou Z Y, Wang G B, Wang X W, Zang Y. Optimization of the groove wheel structural parameters of UAV-based fertilizer apparatus. Transactions of the CSAE, 2021; 37(22): 1-10. (in Chinese)

Fulton J P, Shearer S A, Higgins S F, Hancock D W, Stombaugh T S. Distribution pattern variability of granular vrt applicators. Transactions of the ASAE, 2005; 48(6): 2053-2064.

Song C C, Zang Y, Zhou Z Y, Luo X W, Zhao L L, Ming R, et al. Test and Comprehensive Evaluation for the Performance of UAV-Based Fertilizer Spreaders. IEEE Access, 2020; 8: 202153-202163.

Sugirbay A M, Zhao J, Nukeshev S O, Chen J. Determination of pin-roller parameters and evaluation of the uniformity of granular fertilizer application metering devices in precision farming. Computers and electronics in agriculture, 2020; 179: 105835. doi:org/10.1016/j.compage.2020.105835

Zeng S, Tan Y P, Wang Y, Luo X W, Yao L M, Huang D P, et al. Structural design and parameter determination for fluted-roller fertilizer applicator. Int J Agric & Biol Eng, 2020; 13(2): 101-110.

Sahin M, Habib K. Design and development of an electronic drive and control system for micro-granular fertilizer metering unit. Computers and Electronics in Agriculture, 2019; 162: 921-930. doi.org/10.1016/j.compag.2019.05.048

Zhang M H, Wang Z M, Luo X W, Dai Y Z, He X, Wang B L. Effect of double seed-filling chamber structure of combined type-hole metering device on filling properties. Transactions of the CSAE, 2018; 34(12): 8-15. (in Chinese)

Liu J S, Gao C Q, Nie Y J, Yang B, Ge R Y, Xu Z H. Numerical simulation of Fertilizer Shunt-Plate with uniformity based on EDEM software. Computers and Electronics in Agriculture, 2020; 178: 105737. doi.org/10.1016/j.compag.2020.105737

Sun J F, Chen H M, Duan J L, Liu Z, Zhu Q C. Mechanical properties of the grooved-wheel drilling particles under multivariate interaction influenced based on 3D printing and EDEM simulation. Computers and Electronics in Agriculture, 2020; 172: 105329.doi.org/10.1016/j.compag.2020.105329

Shi Y Y, Chen M, Wang X C, Morice O O, Ding W M. Numerical simulation of spreading performance and distribution pattern of centrifugal variable-rate fertilizer applicator based on DEM software. Computers and electronics in agriculture, 2018; 144: 249-259.doi.org/10.1016/j.compage.2017.12.015

Deng Y P, Mi B G, Zhang Y. Research on numerical calculation for aerodynamic characteristics analysis of ducted fan. Transactions of Journal of Northwestern Polytechnical University, 2018; 36(6): 1045-1051.(in Chinese)

Fernández Oro J M, Pereiras García B, González J, Argüelles Díaz K M, Velarde-Suárez S. Numerical methodology for the assessment of relative and absolute deterministic flow structures in the analysis of impeller–tongue interactions for centrifugal fans. Computers & Fluids, 2013; 86: 310-325. doi.org/10.1016/j.compfluid.2013.07.014

Ye X M, Ding X L, Zhang J K, Li C X. Numerical simulation of pressure pulsation and transient flow field in an axial flow fan. Energy (Oxford), 2017; 129: 185-200. doi.org/10.1016/j.energy.2017.04.076

Li C X, Lin Q, Ding X L, Ye X M. Performance, aeroacoustics and feature extraction of an axial flow fan with abnormal blade angle. Energy (Oxford), 2016; 103: 322-339. doi.org/10.1016/j.energy.2016.02.147

Gao L P, Chen H, Liao Q X, Zhang Q S, Li Y B, Liao Y T. Experiment on Fertilizing Performance of Dynamic Tilt Condition of Seeder with Deep Fertilizer for Rapeseed. Transactions of the CSAM, 2020; 51(S1): 64-72. (in Chinese)

Coetzee C J, Lombard S G. Discrete element method modelling of a centrifugal fertiliser spreader. Biosystems Engineering, 2011; 109(4): 308-325. doi:10.1016/j.biosystemseng.2011.04.011

ASAE. Calibration and Distribution Pattern Testing of Agricultural Aerial Application Equipment. ASAE Standard S386.2. 2013., 2013.

Cool S R., Vangeyte J, Mertens K C., Nuyttens D R E, Sonck B R, Gucht T C V D, et al. Comparing different methods of using collecting trays to determine the spatial distribution of fertiliser particles. Biosystems Engineering, 2016; 150: 142-150.doi.org/10.1016/j.biosystemseng.2016.08.001

Zhan Y L, Chen P C, Xu W C, Chen S D, Han Y F, Lan Y B, et al. Influence of the downwash airflow distribution characteristics of a plant protection UAV on spray deposit distribution. Biosystems Engineering, 2022; 216: 32-45. doi.org/10.1016/j.biosystemseng.2022.01.016

Chen S D, Lan Y B, Zhou Z Y, Fan O Y, Wang G B, Huang X Y, et al. Effect of Droplet Size Parameters on Droplet Deposition and Drift of Aerial Spraying by Using Plant Protection UAV. Agronomy, 2020; 10(2): 195. doi:10.3390/agronomy10020195

Cool S R, Pieters J G, Acker J V, Bulcke J V D, Mertens K C, Nuyttens D R E, et al. Determining the effect of wind on the ballistic flight of fertiliser particles. Biosystems Engineering, 2016; 151: 425-434. doi.org/10.1016/j.biosystemseng.2016.10.011




Copyright (c) 2023 International Journal of Agricultural and Biological Engineering

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

2023-2026 Copyright IJABE Editing and Publishing Office