Airflow field simulation model building and application for aerobic compost using CFD

Qiongyi Cheng, Haibo Meng, Haibin Zhou, Yujun Shen, Hongsheng Cheng, Jingtao Ding, Shihao Zhao, Shance Hou

Abstract


Composting is a suitable low-cost strategy to transform animal waste into a stabilized end product, and the airflow field in the pile affects the fermentation states. For piles in the aeration weak zone, anaerobic fermentation may happen as the lack of oxygen. While in practice, due to the extremely low speed and harsh condition, the airflow field was scarcely researched. This study adopted Computational Fluid Dynamics (CFD) to investigate the airflow field in the compost pile. A three-dimensional CFD model was built; the compost pile in this model was simplified as porous media; unstructured mesh was adopted to discretize the geometric model; standard k-ε model and SIMPLE scheme were employed for numerical methods. The CFD model was validated with the field experiment in the cooling period. Then the model was applied to research the airflow field in the pile with increased pipe diameter. Results showed that it was feasible to investigate the airflow field in the pile with CFD. For boundary conditions in the CFD model, treating the compost pile as a homogeneous porous media is reasonable. The CFD model was successfully validated by the field measurement (the average relative difference between the simulated and measured air speed was within 10%). Airflow in the existing compost pile showed nonuniform distribution with stagnation and vortex zones; the turbulence intensities were 3.57 and 1.43 for the airflow in the pile and the reactor, respectively. When pipe diameter increased, the airflow distribution uniformity in the pile was improved significantly. With diameter raising to 0.04 m, the turbulence intensity decreased to 1.54 and 0.42 for the airflow in the pile and the reactor, respectively. The CFD model developed in this research can provide qualitative and quantitative analyses of the airflow field in compost piles, and can be a theoretical basis for the aeration system design.
Keywords: CFD, model building, compost, airflow field, pile
DOI: 10.25165/j.ijabe.20211404.6087

Citation: Cheng Q Y, Meng H B, Zhou H B, Shen Y J, Cheng H S, Ding J T, et al. Airflow field simulation model building and application for aerobic compost using CFD. Int J Agric & Biol Eng, 2021; 14(4): 245–254.

Keywords


CFD, model building, compost, airflow field, pile

Full Text:

PDF

References


Ministry of Agriculture and Rural Affairs. Being responsibe for promoting the green development of animal husbandry, 2018; Available from: http://www.moa.gov.cn/xw/zwdt/201805/t20180529_6147860.htm.

Rao J R, Watabe M, Stewart T A, Millar B C, Moore J E. Pelleted organo-mineral fertilisers from composted pig slurry solids, animal wastes and spent mushroom compost for amenity grasslands. Waste Management, 2007; 27(9): 1117–1128.

Sato A, Takeda H, Oyanagi W, Nishihara E, Murakami M. Reduction of cadmium uptake in spinach (Spinacia oleracea L.) by soil amendment with animal waste compost. Journal of Hazardous Materials, 2010; 181(1-3): 298–304.

Horne J, Scholes P, Areikin E, Brown B. A survey of the UK organics recycling industry in 2012. WRAP. Banbury: WRAP, 2013.

EPA U. Targeted national sewage sludge survey sampling and analysis technical report. Washington, DC: US Environmental Protection Agency Office of Water, 2009.

Ding F, He Z, Liu S, Zhang S, Zhao F, Li Q, et al. Heavy metals in composts of China: historical changes, regional variation, and potential impact on soil quality. Environmental Science and Pollution Research, 2017; 24(3): 3194–3209.

Bernal M P, Alburquerque J A, Moral R. Composting of animal manures and chemical criteria for compost maturity assessment. A review. Bioresource Technology, 2009; 100(22): 5444–5453.

Guo R, Li G, Jiang T, Schuchardt F, Chen T, Zhao Y, et al. Effect of aeration rate, C/N ratio and moisture content on the stability and maturity of compost. Bioresource Technology, 2012; 112: 171–178.

Cayuela M L, Sánchez-Monedero M A, Roig A. Evaluation of two different aeration systems for composting two-phase olive mill wastes. Process Biochemistry, 2006; 41(3): 616–623.

Yu S, Grant C, Jerry L. Airflow measurement in passively aerated compost. Canadian Biosystems Engineering, 2005; 47(6): 39–45.

Gao M, Li B, Yu A, Liang F, Yang L, Sun Y. The effect of aeration rate on forced-aeration composting of chicken manure and sawdust. Bioresource Technology, 2010; 101(6): 1899–1903.

Yuan J, Chadwick D, Zhang D, Li G, Chen S, Luo W. Effects of aeration rate on maturity and gaseous emissions during sewage sludge composting. Waste Management, 2016; 56: 403–410.

Cerda A, Artola A, Font X, Barrena R, Gea T, Sánchez A. Composting of food wastes: status and challenges. Bioresource Technology, 2018; 248: 57–67.

Zeng J, Shen X, Han L, Huang G. Dynamics of oxygen supply and consumption during mainstream large-scale composting in China. Bioresource Technology, 2016; 220: 104–109.

Poulsen T G. Temperature, pressure and air flow distribution in passively aerated compost piles. Compost Science & Utilization, 2010; 18(2): 127–134.

Yoon N, Piette M A, Han J M, Wu W, Malkawi A. Optimization of Wind Positions for Wind-Driven Natural Ventilation Performance. Energies, 2020; 13(10): 2464–2488.

Gresch M, Armbruster M, Braun D, Gujer W. Effects of aeration patterns on the flow field in wastewater aeration tanks. Water Research, 2011; 45(2): 810–818.

Yang Y, Yang J, Zuo J, Li Y, He S, Yang X, et al. Study on two operating conditions of a full-scale oxidation ditch for optimization of energy consumption and effluent quality by using CFD model. Water Research, 2011; 45(11): 3439–3452.

Bhuyar L, Thakre S, Ingole N. Design characteristics of curved blade aerator wrt aeration efficiency and overall oxygen transfer coefficient and comparison with CFD modeling. International Journal of Engineering, Science and Technology, 2009; 1(1): 1–15.

Xu N, Fan L, Pang H, Shi H. Feasibility study and CFD‐aided design for a new type oxidation ditch based on airlift circulation. The Canadian Journal of Chemical Engineering, 2010; 88(5): 728–741.

Martí-Herrero J, Alvarez R, Rojas M R, Aliaga L, Céspedes R, Carbonell J. Improvement through low cost biofilm carrier in anaerobic tubular digestion in cold climate regions. Bioresource Technology, 2014; 167(169): 87–93.

Wu B. CFD prediction of mixing time in anaerobic digesters. Transactions of the ASABE, 2010; 53(2): 553–563.

Dapelo D, Bridgeman J. Assessment of mixing quality in full-scale, biogas-mixed anaerobic digestion using CFD. Bioresource Technology, 2018; 265: 480–489.

Seyedpour S M, Janmaleki M, Henning C, Sanati-Nezhad A, Ricken T. Contaminant transport in soil: A comparison of the theory of porous media approach with the microfluidic visualisation. Science of the Total Environment, 2019; 686: 1272–1281.

Olatunde G, Atungulu G G, Sadaka S. CFD modeling of air flow distribution in rice bin storage system with different grain mass configurations. Biosystems Engineering, 2016; 151: 286–297.

Qi W K, Guo, Y L, Xue M, Li Y Y. Hydraulic analysis of an upflow sand filter: tracer experiments, mathematical model and CFD computation. Chemical Engineering Science, 2013; 104: 460–472.

Kichah A, Bournet P E, Migeon C, Boulard T. Measurement and CFD simulation of microclimate characteristics and transpiration of an Impatiens pot plant crop in a greenhouse. Biosystems Engineering, 2012; 112(1): 22–34.

Wu W, Zhai J, Zhang G, Nielsen P V. Evaluation of methods for determining air exchange rate in a naturally ventilated dairy cattle building with large openings using computational fluid dynamics (CFD). Atmospheric Environment, 2012; 63: 179–188.

Cheng Q, Li H, Rong L, Feng X, Zhang G, Li B. Using CFD to assess the influence of ceiling deflector design on airflow distribution in hen house with tunnel ventilation. Computers and Electronics in Agriculture, 2018; 151: 165–174.

Zambra C E, Moraga N O, Escudey M. Heat and mass transfer in unsaturated porous media: Moisture effects in compost piles self-heating. International Journal of Heat and Mass Transfer, 2011; 54(13-14): 2801–2810.

Rong L, Nielsen P V, Bjerg B, Zhang G. Summary of best guidelines and validation of CFD modeling in livestock buildings to ensure prediction quality. Computers and Electronics in Agriculture, 2016; 121: 180–190.

Cheng Q, Wu W, Li H, Zhang G, Li B. CFD study of the influence of laying hen geometry, distribution and weight on airflow resistance. Computers and Electronics in Agriculture, 2018; 144: 181–189.

Wu W, Zhang G, Bjerg B, Nielsen P V. An assessment of a partial pit ventilation system to reduce emission under slatted floor–Part 2: Feasibility of CFD prediction using RANS turbulence models. Computers and Electronics in Agriculture, 2012; 83: 134–142.

Chen T B, Luo W, Gao D, Zheng G D. Stratification of bulk density and its dynamics in the process of co-composting. Environmental Science, 2004; 25(5): 143–147.

Cheng Q, Feng H, Meng H, Zhou H. CFD study of the effect of inlet position and flap on the airflow and temperature in a laying hen house in summer. Biosystems Engineering, 2021; 203(4): 109–123.

Alderliesten M. Mean particle diameters. From statistical definition to physical understanding. Journal of Biopharmaceutical Statistics, 2005; 15(2): 295–325.

Zhang Y, Kacira M, An L. A CFD study on improving air flow uniformity in indoor plant factory system. Biosystems Engineering, 2016; 147: 193–205.




Copyright (c) 2021 International Journal of Agricultural and Biological Engineering

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

2023-2026 Copyright IJABE Editing and Publishing Office