Parameter optimization and test of harvesting device for digging and pulling green onions based on discrete element analysis

Wenlong Wang, Dekang Zhang, Xin Wang, Fangyan Wang

Abstract


In green onion harvesting, the problems of easy dumping and low rate of clean digging can be encountered. In this paper, a kind of harvesting device for digging and pulling green onions, referred to simply as "the device", was designed. The device mainly consists of a digging shovel, screen bars, clamping conveyor belt, etc. This paper focuses on the analysis of the model forces of green onions and soil in the two states of the onion digging process without dumping and clamping. The key factors affecting the model state of onions and soil were identified as: screen bar length l2, screen bar inclination angle β, and pulling point position x. Based on the discrete element simulation technology of EDEM, the mechanism-crop-soil model was established, and a single-factor simulation test was conducted to determine the range of values for each factor. Taking the advantages of field test and three-factor five-level orthogonal experimental design, the parameter combinations of green onion harvesting operation evaluation indices were optimized, including a pulling point position of 166 mm, screen bar length of 242 mm, and screen bar inclination angle of 14°. As the results of the field test show, the harvester operation was stable without congestion or damage, the harvesting effect of green onions was improved, and the clean digging rate reached 100%, which meets the agronomic requirements for onion harvesting and the expectations of users.
Keywords: green onions, digging and pulling, clamping, EDEM, test design
DOI: 10.25165/j.ijabe.20251802.9513

Citation: Wang W L, Zhang D K, Wang X, Wang F Y. Parameter optimization and test of harvesting device for digging and pulling green onions based on discrete element analysis. Int J Agric & Biol Eng, 2025; 18(1): 165–172.

Keywords


green onions, digging and pulling, clamping, EDEM, test design

Full Text:

PDF

References


Wang F Y. Production technology and harvesting equipment of green Chinese onion. Agricultural Engineering, 2017; 7(5): 1–4. (in Chinese)

Zhang D X, Zhang J Q, Min L Q, Li Q J, Liu X F, Ren D M. Overview of the whole mechanization process and related equipment of scallion production. Journal of Chinese Agricultural Mechanization, 2020; 41(1): 197–204. (in Chinese)

Hou J L, Chen Y Y, Li Y H, Wang W, Li G H. Development of quantitatively-laying and self-propelled green onion combine harvesters. Transactions of the CSAE, 2020; 36(7): 22–33. (in Chinese)

Zhang D X, Zhang J Q, Liu X F, Qin X T, Li Q J, Min L Q, et al. Design of 4CZ-1 type caterpillar self-propelled integrative machine for scallion harvesting. Journal of Agricultural Mechanization Research, 2022; 44(4): 71–79. (in Chinese)

Hou J L, Chen Y Y, Li Y H, Li T H, Li G H, Guo H E. Design and experiment of shovel-screen combined green onion digging, shaking, and soil tillage device. Transactions of the CSAE, 2021; 37(18): 29–39. (in Chinese)

Wang F Y, Qiu Z C, Pan Y F, Sun G Q. DEM-based parameter optimization and tests of digging green onions. Int J Agric & Biol Eng, 2023; 16(4): 126–133.

Wang F Y, Sun G Q, Shang S Q. Development of 4CL-1 self-propelled combine harvester for green onion. Transactions of the CSAE, 2019; 35(24): 39–47. (in Chinese)

Wang C, Yang Y, Kou T X, Hou S, Hu G F. Theoretical and experimental study on excavation resistance of green Chinese onion harvester. Journal of Agricultural Mechanization Research, 2020; 42(9): 32–38. (in Chinese)

Sun G Q, Pan Y F, Wang F Y. Study on physical and mechanical properties of green onion. Journal of Agricultural Mechanization Research, 2022; 44(11): 159–165, 172. (in Chinese)

Hou J L, Li C, Zhang Z L, Li T H, Li Y H, Wu Y Q. Design and test of double-row walking garlic combine harvester. Transactions of the CSAE, 2021; 37(12): 1–11. (in Chinese)

Li J W, Li X Y, Hu B, Gu T L, Wang Z J, Wang H L. Analysis of the resistance reduction mechanism of potato bionic digging shovels in clay and heavy soil conditions. Computers and Electronics in Agriculture, 2023; 214: 108315.

Liu L, Wang X L, Zhang X C, Cheng X P, Wei Z C, Zhou H, et al. The impact of ‘T’ -shaped furrow opener of no-tillage seeder on straw and soil based on discrete element method. Computers and Electronics in Agriculture, 2023; 213: 108278.

Lü J Q, Yang X H, Lü Y N, Li Z H, Li J C, Du C L. Analysis and experiment of potato damage in process of lifting and separating potato excavator. Transactions of the CSAM, 2020; 51(1): 103–113. (in Chinese)

Sun J F, Chen H M, Wang Z M, Ou Z W, Yang Z, Liu Z, Duan J L. Study on plowing performance of EDEM low-resistance animal bionic device based on red soil. Soil & Tillage Research, 2020; 196.

Wang F A, Ni C, Zhang Z G, Xu H W, Xie K T, Wang B Y. Analysis and experiment on drag reduction characteristics of digging shovel of Panax notoginseng harvester. Transactions of the CSAM, 2024; 55(7): 179–190, 199. (in Chinese)

Zhang P C, Li F G, Wang F Y. Optimization and test of ginger-shaking and harvesting device based on EDEM software. Computers and Electronics in Agriculture, 2023; 213: 108257.

Wang J W, Li X, Gao P X, Na M J, Wang Q, Zhou W Q. Design and experiment of high efficiency drag reducing shovel for carrot combine harvester. Transactions of the CSAM, 2020; 51(6): 93–103. (in Chinese)

Xia C, Shang S Q, Wang D W, Liu Y G, He X N, Zhao Z, et al. Design and research of bionic scallop peanut excavation shovel. Journal of Agricultural Mechanization Research, 2024; 46(3): 114–119. (in Chinese)

Ma W N, Song Q, Gao X Y, Zhao J G, Ma C Y. Design and experiment of saposhnikovia divaricata bionic digging shovel. Journal of Agricultural Mechanization Research, 2024; 46(7): 64–72. (in Chinese)

Sun N, Shi X L, Chen Y, Li J L, Yang G. Design and testing of potato digging device based on EDEM. Journal of Agricultural Mechanization Research, 2024; 46(11): 29–34, 44. (in Chinese)

Zhang Z G, Xue H T, Wang Y C, Xie K T, Deng Y X. Design and experiment of Panax notoginseng bionic excavating shovel based on EDEM. Transactions of the CSAM, 2022; 53(5): 100–111. (in Chinese)

Chen M D, Liu X T, Hu P X, Zhai X T, Han Z L, Shi Y L, et al. Study on rotor vibration potato-soil separation device for potato harvester using DEM-MBD coupling simulation. Computers and Electronics in Agriculture, 2024; 218: 108638.

Li J W, Gu T L, Li X Y, Wang Z J, Hu B, Ma Y H. Analysis and experiment of the bionic drag reduction characteristics of potato digging shovels on clayey black soil conditions. Transactions of the CSAE, 2023; 39(20): 1–9. (in Chinese)

Zou L L, Yan D W, Niu Z R, Yuan J, Cheng H, Zheng H. Parametric analysis and numerical optimisation of spinach root vibration shovel cutting using discrete element method. Computers and Electronics in Agriculture, 2023; 212: 108138.

Tao G X, Zhang Z H, Yi S J, Xia C L, Ma Y C. Design and test of combined swing radix isatidi root-soil separation device. Transactions of the CSAM, 2022; 53(4): 109–119. (in Chinese)

Xiao X, Xie F P, Zhao Z Q, Wang X S, Liu D W, Zhao Y. Optimized design and experiment of the tassel gathering mechanism for 4BL-1 type white radish combine harvester. Transactions of the CSAE, 2024; 40(11): 38–47. (in Chinese)

Zhang J, Wang J, Du D D, Long S F, Wang Y W, Han C J, et al. Optimization and validation of root-cutting device for Chinese cabbage harvester based on discrete element method. Computers and Electronics in Agriculture, 2023; 214: 108314.

Dai Z W, Wu M L, Fang Z C, Qu Y B, Liu Y F. Design and test of a throwing roller type lily bulb harvester. Transactions of the CSAE, 2023; 39(12): 20–29. (in Chinese)

Zhang G Z, Zhang Q H, Liu W R, Li Z H, Zhou Y, Liu H P. Spring roller device for soil-corm separation for a water chestnut harvester. Transactions of the CSAE, 2024; 40(2): 164–175. (in Chinese)

Chen Q Y, Zhang S X, Wei N S, Li P H, Hu G R, Chen J, Chen Y. Design and optimization of torsion harvester of Lycium barbarum L. Int J Agric & Biol Eng, 2024; 17(4): 109–115.

Wang F Y, Zhang Q, Zhang Z Y, Huang X P. Development of comb type leaves clearing and top cutting machine for beets. Transactions of the CSAE, 2021; 37(4): 69–79. (in Chinese)

Wang F Y. Optimization and field experiment of an adjustable device for sugar beet digger. Int J Agric & Biol Eng, 2021; 14(6): 68–74.

Yang R B, Tian G B, Shang S Q, Wang B J, Zhang J, Zhai Y M. Design and experiment of roller group type potato soil separator for potato harvester. Transactions of the CSAM, 2023; 54(2): 107–118. (in Chinese)

Yang S D, Qiu T Y, Ma C, Li X Q, Wang L L, Liu Y. Design and test of sugar beet combine harvester separation and conveying device. Transactions of the CSAM, 2023; 54(S1): 191–200. (in Chinese)




Copyright (c) 2025 International Journal of Agricultural and Biological Engineering

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

2023-2026 Copyright IJABE Editing and Publishing Office