Electronic control seed-metering system for precision seeding maize based on fuzzy PID

Xiaoshun Zhao, Hongpeng Zhao, Zehe Wang, Jincai Li, Huali Yu, Qing Yan

Abstract


Aiming at the problem of poor uniformity of maize sowing caused by ground wheel slip, an electronic control seed-metering system (ECSMS) for maize single seed precision sowing was designed and a mathematical model for motor control of the ECSMS was determined. The PID parameters were set by Z-N method and fuzzy control. The fuzzy PID control design and Simulink simulation were completed by MATLAB, which reduced response time of the system by 0.23 s and improved the control accuracy. Experiments on the JPS-12 test bench show that the qualification index (QI) of maize seed-metering device with the ECSMS increases by 4.47%, the multiples index (MI) decreases by 1.96%, the miss index (MIX) decreases by 2.81%, and the coefficient of variation (CV) of qualified seed spacing decreases by 5.06%, and the sowing uniformity has been greatly improved. Test results of the soil-tank test bench show that the system has good sowing uniformity and stability. And the QI is 96.74%, the MI is 2.15%, the MIX is 1.10%, and the CV of qualified seed spacing is 16.24%. Under different setting seed spacing and different sowing operation speed, the change range of seeding quality index was within 10%. The results of field sowing test show that the QI was 84.21%, the MI was 2.63%, the MIX was 7.89%, and the CV of qualified seed spacing was 22.15%, which meet the requirements of JB/T 10293-2013 ‘Specification for single seed planters (precision planters)’ and the agronomic requirements for maize precision sowing. The system runs stably and reliably in practical operation and has good operation performance.
Key words: maize; seed-metering system; electronic control; precision sowing; parameters tuning; fuzzy PID control; simulink simulation
DOI: 10.25165/j.ijabe.20241704.8247

Citation: Zhao X S, Zhao H P, Wang Z H, Li J C, Yu H L, Yan Q. Electronic control seed-metering system for precision seeding maize based on fuzzy PID. Int J Agric & Biol Eng, 2024; 17(4): 217–226.

Keywords


maize; seed-metering system; electronic control; precision sowing; parameters tuning; fuzzy PID control; simulink simulation

References


Zhao X S, Bai W J, Li J C, Yu H L, Zhao D W, Yin B Z. Study on positive-negative pressure seed metering device for wide-seedling-strip-seeding. Int J Agric & Biol Eng, 2022; 15(6): 124–133.

Liu K, Yi S J. Design and experiment of seeding performance monitoring system for suction corn planter. Int J Agric & Biol Eng, 2019; 12(4): 97–103.

Zhao X S, Ran W J, Hao J J, Bai W J, Yang X L. Design and experiment of the double-seed hole seeding precision seed metering device for peanuts. Int J Agric & Biol Eng, 2022; 15(3): 107–114.

Yuan Y W, Bai H J, Fang X F, et al. Research progress on maize seeding and its measurement and control technology. Transactions of the CSAM, 2018; 49(9): 1–18. (in Chinese)

Lei X L, Hu H J, Yang W H, Liu L Y, Liao Q X, Ren W J. Seeding performance of air-assisted centralized seed-metering device for rapeseed. Int J Agric & Biol Eng, 2021; 14(5): 79–87.

Liu J X, Wang Q J, Li H W, He J, Lu C Y. Design and seed suction performance of pinhole-tube wheat precision seeding device. Transactions of the CSAE, 2019; 35(11): 10–18. (in Chinese)

Jin X, Li Q W, Yuan Y W, Qiu Z M, Zhou L M, He Z T. Design and test of 2BFJ-24 type variable fertilizer and wheat precision seed sowing machine. Transactions of the CSAM, 2018; 49(5): 84–92. (in Chinese)

Lai Q H, Sun K, Yu Q X, Qin W. Design and experiment of a six-row air-blowing centralized precision seed-metering device for Panax notoginseng. Int J Agric & Biol Eng, 2020; 13(2): 111–122.

Ding Y Q, Yang L, Zhang D X, Cui T, He X T, Zhong X J. Design of row-unit driver for maize variable rate planter. Transactions of the CSAE, 2019; 35(11): 1–9. (in Chinese)

Cheng X P, Li H W, He J, Wang Q J, Lu C Y, Wang Y B. Optimization of operating parameters of seeding device in plot drill with seeding control system. Int J Agric & Biol Eng, 2021; 14(3): 83–91.

He J, Zhu J G, Zhang Z G, Luo X W, Gao Y, Hu L. Design and experiment of automatic operation system for rice transplanter. Transactions of the CSAM, 2019; 50(3): 17–24. (in Chinese)

Ding Y C, He Z B, Xia Z Z, Peng J Y, Wu T H. Design of navigation immune controller of small crawler-type rape seeder. Transactions of the CSAE, 2019; 35(7): 12–20. (in Chinese)

Yang S, Wang X, Gao Y Y, Zhao X G, Dou H J, Zhao C J. Design and experiment of motor driving bus control system for corn vacuum seed meter. Transactions of the CSAM, 2019; 50(2): 57–67. (in Chinese)

Kang J M, Peng Q J, Zhang C Y, Zhang N N, Fang H M. Design and testing of a punching-on-film precision hole seeder for peanuts. Transactions of the ASABE, 2020; 63(6): 1685–1696.

Cheng X P, Li H W, Wang Q J, He J, Lu C Y, Yang W. Design and experiment of wheat seeding control system in plot seeder. Transactions of the CSAM, 2019; 50(7): 30–38. (in Chinese)

Kamgar S, Noei-Khodabadi F, Shafaei S M. Design development and field assessment of a controlled seed metering unit to be used in grain drills for direct seeding of whea. Information Processing in Agriculture, 2015; 2(3-4): 169–176.

Jafari M, Hemmat A, Sadeghi M. Development and performance assessment of a DC electric variable-rate controller for use on grain drills. Computers and Electronics in Agriculture, 2010; 73(1): 56–65.

Kim Y J, Kim H J, Ryu K H, Rhee J Y. Fertiliser application performance of a variable-rate pneumatic granular applicator for rice production. Biosystems Engineering, 2008; 100(4): 498–510.

Zhou X H, Li D L, Zhang L, Duan Q L. Application of an adaptive PID controller enhanced by a differential evolution algorithm for precise control of dissolved oxygen in recirculating aquaculture systems. Biosystems Engineering, 2021; 208: 186–198.

Wang Y Z, Zhang H W, Wang L, Li G Y, Zhang Y, Liu X M. Development of control system for cotton picking test bench based on fuzzy PID control. Transactions of the CSAE, 2018; 34(23): 23–32. (in Chinese)

Han B, Yang Y N, Wang H W, Fan W. Design of PID automatic control system for depth into earth of intra-row weeding components and its bench experiment. Transactions of the CSAE, 2018; 34(11): 68–77. (in Chinese)

Yao J F, Lu J, Zheng Y L, Wang X F, Zhao Y D, Chen X C, et al. DC motor speed control of annual-ring measuring instrument based on variable universe fuzzy control algorithm. Transactions of the CSAE, 2019; 35(14): 57–63. (in Chinese)

Zhou X H, Wang J P, Huang L, Li D L, Duan Q L. Modelling and controlling dissolved oxygen in recirculating aquaculture systems based on mechanism analysis and an adaptive PID controller. Computers and Electronics in Agriculture, 2021; 192: 0168–1699.

Cheng Z, Lu Z. Research on the PID control of the ESP system of tractor based on improved AFSA and improved SA. Computers and Electronics in Agriculture, 2018; 148: 142–147.

Elebaid J I, Liao Q X, Wang L, Liao Y T, Yao L. Design and experiment of multi-row pneumatic precision metering device for rapeseed. Int J Agric & Biol Eng, 2018; 11(5): 116–123.

Cao F Y, Li H D, Yan X H, Xu L Y. Hydro-mechanical compound transmission constant rotational speed output control method under step input based on double feedforward and fuzzy PID. Transactions of the CSAE, 2019; 35(1): 72–82. (in Chinese)

Goodchild M S, Jenkins M D, Whalley W R, Watts C W. A novel dielectric tensiometer enabling precision PID-based irrigation control of polytunnel-grown strawberries in coir. Biosystems Engineering, 2018; 165: 70–76.

Chen L Q, Xie B B, Li Z D, Yang L, Chen Y X. Design of control system of maize precision seeding based on double closed loop PID fuzzy algorithm. Transactions of the CSAE, 2018; 34(9): 33–41. (in Chinese)

Ding Y C, Yang J Q, Zhang L L, Zhu K. Design and experiment on variable reseeding system for rapeseed precision metering device. Transactions of the CSAE, 2018; 34(16): 27–36. (in Chinese)

Yang L, Yan B X, Cui T, Yu Y M, He X T, Liu Q W. Global overview of research progress and development of precision maize planters. Int J Agric & Biol Eng, 2016; 9(1): 9–26.

Zhao X S, Zhao D W, Chi D D, Huo Q, Bai W J, Ran W J. Design and test of precision electronic metering system for wheat wide seedling belt based on EDEM-Fluent coupling simulation. Journal of Hebei Agricultural University, 2022; 45(1): 105–114, 120.




Copyright (c) 2024 International Journal of Agricultural and Biological Engineering

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

2023-2026 Copyright IJABE Editing and Publishing Office