Design and experiment of vertical pneumatic fertilization system with spiral Geneva mechanism

Haibo Chen, Jingfu Zheng, Shaojie Lu, Shan Zeng, Silong Wei

Abstract


In the traditional fertilization method, a large amount of fertilizer is applied, which causes congestion easily. It is not conducive to the sustainable development of agriculture. In this work, a vertical pneumatic fertilization system with a spiral Geneva mechanism was designed according to the operational requirements of variable-rate and smooth fertilization. The uniformity in discharging fertilizer with different spiral angles was simulated and analyzed by extended discrete element method (EDEM) based simulation software, from where the spiral angle of the fertilizer discharge wheel was determined to be 45°. The fertilization system includes a fertilizer apparatus with a spiral Geneva mechanism, whose optimal performance parameters were obtained from the bench experiment. The accuracy and uniformity of the fertilizer application system were taken as the evaluation indicators. The linear relationships of the discharged amount of fertilizer with the rotational speed and the opening of the fertilizer discharging wheel were verified by both static blowing fertilization and field experiments. The static blowing experimental results show that the discharged amount of fertilizer has a high linear correlation and accuracy with both the opening and rotational speed, and the highest correlation occurs with the rotational speed. The rotational speed and opening have significant effects on the discharged amount of fertilizer and the average coefficient of variation. The effect of the rotational speed was the most significant. According to the model obtained by multiple regression fittings, the optimal parameters were determined when the average coefficient of variation was small, the rotational speed was 15.9 r/min and the opening was 34.4 mm. Therefore, the purpose of precise fertilization can be achieved by adjusting the opening or rotational speed in a way to get the exact amount of fertilizer discharged as required by the corresponding crops. The field experiment showed that the variation coefficient of each fertilizer discharged decreases first and then increases with an increasing opening under different rotational speeds, which is consistent with the theoretical value. When the opening was 40 mm or 50 mm, the variation coefficient reached the minimum value, which is far less than the qualified index of 7.8%. In the static blowing experiment and the dynamic field experiment, the stability of the fertilizer discharging device can be significantly enhanced with the utilization of the pneumatic conveying fertilizer. This study can provide a theoretical reference for parameter selection and optimization of vertical spiral fertilization systems.
Keywords: precision fertilization, fertilizer apparatus, variable rate technology, spiral Geneva mechanism, simulation analysis, performance experiment
DOI: 10.25165/j.ijabe.20211404.6575

Citation: Chen H B, Zheng J F, Lu S J, Zeng S, Wei S L. Design and experiment of vertical pneumatic fertilization system with spiral Geneva mechanism. Int J Agric & Biol Eng, 2021; 14(4): 135–144.

Keywords


precision fertilization, fertilizer apparatus, variable rate technology, spiral Geneva mechanism, simulation analysis, performance experiment

Full Text:

PDF

References


Ministry of Agriculture and Rural Affaires of the People's Republic of China. Ten-tear development plan of Mechanization of rice production in China (2006-1015): Available: http://www.moa.gov.cn/gk/ghjh_1/201006/ t20100606_1534739.htm. Accessed on [2020-01-09]

Liu B Y. Control method of variable rate fertilization research. Harbin: Northeast Forestry University, 2013; 6. 267p. (in Chinese)

Yuan W S, Jin M, Wu C Y, Xiao T Q. Development status and prospect of seed manure fertilizing mechanization in China. Journal of Agricultural Mechanization Research, 2011; 12: 1–5. (in Chinese)

Gao Q, Liu S X, Wang Y, Chen L R. Effects of fertilization on agricultural ecological environment. Journal of Jilin Agricultural University, 2000; 22(Album): 106–112. (in Chinese)

Wang H Y, Zhou J M. Calculation of real fertilizer use efficiency and discussion on fertilization strategies. Acta Pedologica Sinica, 2014; 51(2): 216–225.

Yang Q L, Sang L M, Sun J R, Ji Z Q, Yuan W L, Guo Y W, et al. Current situation of fertilizer use in China and the method to improve chemical fertilizer utilization efficiency. Journal of Shanxi Agricultural Sciences, 2011; 39(7): 690–692.

Wang H Y, Li J. Improve the application technology of chemical fertilizers. Agriculture and Technology, 2014; 34(7): 104. (in Chinese)

Koch B, Khosla R, Frasier W M, Westfall D G, Inman D. Economic feasibility of variable-rate nitrogen application utilizing site-specific management zones. Agron. J, 2004; 96: 1572. doi: 10.2134/agronj2004.1572.

Qi J T, Tian X L, Li Y, Fan X H, Yuan H F, Zhao J L, et al. Design and experiment of a subsoiling variable rate fertilization machine. Int J Agric & Biol Eng, 2020; 13(4): 118–124.

Zha X T, Zhang G Z, Zhang S J, Hou Q X, Wang Y, Zhou Y. Design and experiment of centralized pneumatic deep precision fertilization device for rice transplanter. Int J Agric & Biol Eng, 2020; 13(6): 109–117.

Chen M, Yang Z J, Wang X C, Shi Y Y, Zhang Y. Response characteristics and efficiency of variable rate fertilization based on spectral reflectance. Int J Agric & Biol Eng, 2018; 11(6): 152–158.

Du R C, Gong B C, Liu N N, Wang C C, Yang Z D, Ma M J. A design and experiment on intelligent fuzzy monitoring system for corn planters. Int J Agric & Biol Eng, 2013; 6(3): 11–18.

Zhou W Q, Wang J W, Tang H. Structure optimization of cam executive component and analysis of precisely applying deep-fertilization liquid fertilizer. Int J Agric & Biol Eng, 2019; 12(4): 104–109.

Yang L, Chen L, Zhang J, Liu H, Sun Z, Sun H, et al. Fertilizer sowing simulation of a variable-rate fertilizer apparatus based on EDEM. IFAC-PapersOnLine, 2018; 51: 418–423.

Shi Y Y, Hu Z Z, Wang X C, Odhiambo M O, Sun G X. Fertilization strategy and application model using a centrifugal variable-rate fertilizer spreader. Int J Agric & Biol Eng, 2018; 11(6): 41–48.

Chen C, He P, Zhang J, Li X, Ren Z, Zhao J, et al. A fixed-amount and variable-rate fertilizer apparatus based on pulse width modulation. Comput. Electron. Agr, 2018; 148: 330–336.

Zeng S, Tan Y P, Wang Y, Luo X W, Yao L M, Huang D P, et al. Structural design and parameter determination for fluted-roller fertilizer applicator. Int J Agric & Biol Eng, 2020; 13(2): 101–110.

Su N, Xu T S, Song L T, Wang R J, Wei Y Y. Variable rate fertilization system with adjustable active feed-roll length. Int J Agric & Biol Eng, 2015; 8(4): 19–26.

Chen X F, Luo X W, Wang Z M, Zhang M H, Hu L, Yang W W, et al. Design and experiment of fertilizer distribution apparatus with double-level screws. Transactions of the CSAE, 2015; 31(3): 10–16. (in Chinese)

Pan S Q, Zhao Y X, Jin L, Qu G B, Tian Y. Design and experimental research of external grooved wheel fertilizer apparatus of 2BFJ-6 type variable rate fertilizer application. Journal of Chinese Agricultural Mechanization, 2016; 37(1): 40–42. (in Chinese)

Shi Y Y, Chen M, Wang X C, Odhiambo M O, Zhang Y N, Ding W M. Analysis and experiment of fertilizing performance for precision fertilizer apparatus in rice and wheat fields. Transaction of the CSAM, 2017; 48(7): 97–103. (in Chinese)

Yuan J, Liu C, Li Y, Zeng Q, Zha X F. Gaussian processes based bivariate control parameters optimization of variable-rate granular fertilizer apparatus. Comput. Electron. Agr, 2010; 70: 33–41.

Lv H, Yu J Q, Fu H. Simulation of the operation of a fertilizer spreader based on an outer groove wheel using a discrete element method. Mathematical and Computer Modelling, 2013; 58: 842–851.

Ishola T A, Yahya A, Shariff A R M, Aziz S A. Novel variable rate pneumatic fertilizer applicator. Instrumentation Science & Technology, 2014; 42(4): 369–384.

Zhang T, Liu F, Liu Y Q, Zhao M Q, Zhang S, Li N, et al. Discrete element simulation of outer groove wheel type fertilizer discharging device capacity analysis. Journal of Agricultural Mechanization Research, 2015; 37(09): 198–201.

Ding S, Bai L, Yao Y, Yue B, Fu Z, Zheng Z, et al. Discrete element modelling (DEM) of fertilizer dual-banding with adjustable rates. Comput. Electron. Agr., 2018; 152: 32–39.

Li K, Zhang L X, Zhang L P, Chu S Z, Qi X M, Qian Y, et al. Design and experiment of bivariate fertilizer. Journal of Gansu Agricultural University, 2016; 51(4): 128–133. (in Chinese)

Wang Z M, Luo X W, Tang X R, Ma G H, Zhang G Z, Zeng S. Precision rice hill-direct-seeding technology and machine based on the combination of agricultural machinery and agronomic technology. Journal of South China Agricultural University, 2010; 31(1): 91–95. (in Chinese)

Yang Z, Zhu Q C, Sun J F, Chen Z C, Zhang Z W. Study on the performance of fluted roller fertilizer distributor based on EDEM and 3D Printing. Journal of Agricultural Mechanization Research, 2018; 40(5): 175–180. (in Chinese)

Hu G M. Analysis and simulation of granular system by discrete element method using EDEM. Wuhan: Wuhan University of Technology Press, 2010. (in Chinese)

Barrios G K P, Carvalho R M, Kwade A, Tavares L M. Contact parameter estimation for DEM simulation of iron ore pellet handling. Powder Technology, 2013; 248: 84–93.




Copyright (c) 2021 International Journal of Agricultural and Biological Engineering

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

2023-2026 Copyright IJABE Editing and Publishing Office