Design and experiment of a hydraulic lifting wind field test platform for crop protection UAS

Songchao Zhang, Wei Gu, Baijing Qiu, Xinyu Xue, Lixin Zhou

Abstract


As a new type of crop protection machine, the crop protection unmanned aerial system (CPUAS) is developing rapidly in China. The wind field generated by the rotor has a great influence on the deposition and penetration of spraying droplets. The purpose of this study was to develop a reliable and stable test platform that could be used for wind field test of CPUAS, and to carry out the downwash experiments on the platform to obtain the downwash distribution law of a CPUAS Z-3N (100 kg level, Nanjing Research Institute on Simulation Technique, Nanjing, China). The tests showed that the performances of the developed platform could meet the expected design requirements. The platform operated stably and reliably during the downwash experiments of Z-3N, which indicated it could be applied for CPUASs of 100 kg level and below. The vibration characteristics of the platform with different heights (2.0 m, 3.0 m, 5.0 m, 7.0 m, 10.0 m) were obtained through modal analysis, which could effectively guide avoiding the resonance for stable and reliable operation during the experiments with the tested CPUAS Z-3N. A ring-radial method was designed combined with the platform for the downwash measurement. The experimental results showed that the downwash distribution of Z-3N was not symmetrical; the downwash wind speed decreased with the increase of the radial distance while the changing trend was not consistent as the height increased. Moreover, the area with high wind speed was mainly within 3.0 m of the radial distance, and the maximum value was 11.37 m/s. The study provided a new way for wind field test of CPUASs and would provide some references for better utilization of wind field during the CPUAS spraying.
Keywords: crop protection, unmanned aircraft system, wind field, test platform, vibration modal, aerial spraying
DOI: 10.25165/j.ijabe.20211404.6262

Citation: Zhang S C, Gu W, Qiu B J, Xue X Y, Zhou L X. Design and experiment of a hydraulic lifting wind field test platform for crop protection UAS. Int J Agric & Biol Eng, 2021; 14(4): 166–174.

Keywords


crop protection, unmanned aircraft system, wind field, test platform, vibration modal, aerial spraying

Full Text:

PDF

References


Xue X Y, Qin W C, Sun Z, Zhang S C, Zhou L X, Wu P. Effects of N-3 UAV spraying methods on the efficiency of insecticides against planthoppers and Cnaphalocrocis medinalis. Acta Phytophylacica Sinica, 2013; 40(3): 273–278. (in Chinese)

Mozhdeh S. Jérôme T, Patrick M. Recent applications of unmanned aerial imagery in natural resource management. Giscience & Remote Sensing, 2014; 51(4): 339–365.

Qin W C, Qiu B J, Xue X Y, Chen C, Xu Z F, Zhou Q Q. Droplet deposition and control effect of insecticides sprayed with an unmanned aerial vehicle against plant hoppers. Crop Protection, 2016; 85: 79–88.

Koo Y M, Bae Y H, Seok T S, Shin S K, Park H J. Tail rotor design and thrust test for a roll-balanced agricultural unmanned helicopter. Journal of Biosystems Engineering, 2010; 35(5): 302–309.

Li J Y, Guo S, Yao W X, Zhan Y L, Li Y F. Distribution characteristics of droplet size in rice field and wind tunnel simulation test under airflow operation. Transactions of the CSAM, 2019; 50(8): 148–156. (in Chinese)

Yang F B, Xue X Y, Zhang L, Sun Z. Numerical simulation and experimental verification on downwash air flow of six-rotor agricultural unmanned aerial vehicle in hover. Int J Agric & Biol Eng, 2017; 10(4): 41–53.

Liao J, Zang Y, Luo X W, Zhou Z Y, Lan Y B, Zang Y, et al. Optimization of variables for maximizing efficacy and efficiency in aerial spray application to cotton using unmanned aerial systems. Int J Agric & Biol Eng, 2019; 12(2): 10–17.

Wang G B, Lan Y B, Qi H X, Chen P C, Hewitt A J, Han Y X. Field evaluation of an unmanned aerial vehicle (UAV) sprayer, effect of spray volume on deposition and the control of pests and disease in wheat. Pest Management Science, 2019; 75(6): 1546–1555.

Chen S D, Lan Y B, Li J Y, Zhou Z Y, Liu A M, Mao Y. Effect of wind field below unmanned helicopter on droplet deposition distribution of aerial spraying. Int J Agric & Biol Eng, 2017; 10(3): 67–77.

Chen P C, Lan Y B, Huang X Y, Qi H X, Wang G B, Wang J, et al. Droplet deposition and control of plant hoppers of different nozzles in two-stage rice with a quadrotor unmanned aerial vehicle. Agronomy, 2020; 10(2): 303. doi: 10.3390/agronomy10020303.

Lou Z X, Xin F, Han X Q, Lan Y B, Duan T Z, Fu W. Effect of unmanned aerial vehicle flight height on droplet distribution, drift and control of cotton aphids and spider mites. Agronomy, 2018; 8(9): 187. doi: 10.3390/agronomy8090187.

Xue X Y, Gu W, Xu Y, Sun Z, Lan Y B. Review on current state of agricultural UAS regulations and standards. Transactions of the CSAM, 2020; 51(10): 1–10. (in Chinese)

Zhou Z Y, Ming R, Zang Y, He X G, Luo X W, Lan Y B. Development status and countermeasures of agricultural aviation in China. Transactions of the CSAE, 2017; 33(20): 1–13. (in Chinese)

Yang S L, Yang X B, Mo J Y. The application of unmanned aircraft systems to plant protection in China. Precision Agriculture, 2018; 19: 278–292.

He X K, Bonds J, Herbst A, Langenakens J. Recent development of unmanned aerial vehicle for plant protection in East Asia. Int J Agric & Biol Eng, 2017; 10(3): 18–30.

Zhang S C, Qiu B J, Xue X Y, Sun T, Peng B. Parameters optimization of crop protection UAS based on the first industry standard of China. Int J Agric & Biol Eng, 2020; 13(3): 29–35.

Wang G B, Han Y X, Li X, Andaloro J, Lan Y B. Field evaluation of spray drift and environmental impact using an agricultural unmanned aerial vehicle (UAV) sprayer. Science of The Total Environment, 2020; 737: 139793. doi: 10.1016/j.scitotenv.2020.139793.

Zhang S C, Xue X Y, Qin W C, Sun Z, Ding S M, Zhou L X. Simulation and experimental verification of aerial spraying drift on N-3 unmanned spraying helicopter. Transactions of the CSAE, 2015; 31(3), 87–93. (in Chinese)

Yang F B, Xue X Y, Cai C, Zhou Q Q. Effect of down wash airflow in hover on droplet motion law for multi-rotor unmanned plant protection machine. Transactions of the CSAE, 2018; 34(2): 64–73. (in Chinese)

Xue X Y, Tu K, Qin W C, Lan Y B, Zhang H H. Drift and deposition of ultra-low altitude and low volume application in paddy field. Int J Agric & Biol Eng, 2014; 7(4): 23–28.

Tang Q, Zhang R R, Chen L P, Xu M, Zhang B. Droplets movement and deposition of an eight-rotor agricultural UAV in downwash flow field. Int J Agric & Biol Eng, 2017; 10(3): 47–56.

Lyu M Q, Xiao S P, Tang Y, He Y. Influence of UAV flight speed on droplet deposition characteristics with the application of infrared thermal imaging. Int J Agric & Biol Eng, 2019; 12(3): 10–17.

Jung Y S, You J Y, Kwon O J. Numerical investigation of prop-rotor and tail-wing aerodynamic interference for a tilt-rotor UAV configuration. Journal of Mechanical Science and Technology, 2014; 28(7): 2609–2617.

Yoon S, Lee H C, Pulliam T H. Computational analysis of multi-rotor flows. In: American Institute of Aeronautics and Astronautics, 54th Aerospace Sciences Meeting, San Diego, USA, 2016; pp.812–823.

Zheng Y J, Yang S H, Liu X X, Wang J, Norton T, Chen J, et al. The computational fluid dynamic modeling of downwash flow field for a six-rotor UAV. Frontiers of Agricultural Science and Engineering, 2018; 5(2): 159–167.

Li J Y, Shi Y Y, Lan Y B, Guo, S. Vertical distribution and vortex structure of rotor wind field under the influence of rice canopy. Computers and Electronics in Agriculture, 2019; 159: 140–146.

Wang P, Hu L, Zhou Z Y, Yang W S, Liu A M, Luo X W, et al. Wind field measurement for supplementary pollination in hybrid rice breeding using unmanned gasoline engine single-rotor helicopter. Transactions of the CSAE, 2013; 29(3): 54–61. (in Chinese)

Hu L, Zhou Z Y, Luo X W, Wang P, Yan Y A, Li J Y. Development and experiment of a wireless wind speed sensor network measurement system for unmanned helicopter. Transactions of the CSAM, 2014; 45(5): 194–201. (in Chinese)

Wang C L, He X K, Wang X N, Bonds J, Herbst A, Wang Z G, et al. Testing method of spatial pesticide spraying deposition quality balance for unmanned aerial vehicle. Transactions of the CSAE, 2016; 32(11): 54–61. (in Chinese)

Pombeiro R, Mendona R, Rodrigues P, Marques F, Barata J. Water detection from downwash-induced optical flow for a multirotor UAV. OCEANS 2015-MTS/IEEE, Washington, USA, 2015; pp.1–6.

Mylapore A R, Schmitz F H. An experimental investigation of ground effect on a quad tilt rotor in hover. Journal of the American Helicopter Society, 2015; 60(1): 1–14.

Guo Q W, Zhu Y Z, Tang Y, Hou C J, He L, Zhuang J J, et al. CFD simulation and experimental verification of the spatial and temporal distributions of the downwash airflow of a quad-rotor agricultural UAV in hover. Computers and Electronics in Agriculture, 2020; 172: 105343. doi: 10.1016/j.compag.2020.105343.

Tang Q, Zhang R R, Chen L P, Xu G, Li L L. High-accuracy, high-resolution downwash flow field measurements of an unmanned helicopter for precision agriculture. Computers and Electronics in Agriculture, 2020; 173: 105390. doi: 10.1016/j.compag.2020.105390.

Lan Y B, Chen S D, Fritz B K. Current status and future trends of precision agricultural aviation technologies. Int J Agric & Biol Eng, 2017; 10(3): 1–17.

Wu P. Power-train dynamical analysis based on testing and computational modals. Chinese Journal of Construction Machinery, 2013; 11(6): 534–536,541.

Zhang X Y, Lu Z H, Wu S Y, Zhao Y G. An efficient method for time-variant reliability including finite element analysis. Reliability Engineering & System Safety, 2021; 210: 107534. doi: 10.1016/j.ress.2021.107534.

Guo Q, Yao W J, Li W B, Gupta N. Constitutive models for the structural analysis of composite materials for the finite element analysis: a particular review of recent practices. Composite Structures, 2021; 260: 113267. doi: 10.1016/j.compstruct.2020.113267.

Kweon H D, Kim J W, Song O, Oh D. Determination of true stress-strain curve of type 304 and 316 stainless steels using a typical tensile test and finite element analysis. Nuclear Engineering and Technology, 2021; 53: 647–656.

Maeda R, Wang Z L, Ogawa T, Adachi Y. Stress–strain partitioning behavior and mechanical properties of dual-phase steel using finite element analysis. Materials Today Communications, 2020; 25: 101658. doi: 10.1016/j.mtcomm.2020.101658.

Liu H S, Luo D. The research and application of vibration modal test and simulation analysis. Mechanical Management and Development, 2018; 4: 38–41.




Copyright (c) 2021 International Journal of Agricultural and Biological Engineering

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

2023-2026 Copyright IJABE Editing and Publishing Office