Mathematical modeling of microwave drying of crashed cotton stalks for man-made composite material

Wang Hongti, Li Peng, Guo Kangquan

Abstract


Drying characteristics, energy consumption and drying kinetics modeling of crashed cotton stalks dried in a microwave dryer were investigated in this research. A microwave dryer with an output power of 1000 W and 2450 MHz was employed, and the effects of material load ranging from 50 g to 250 g on drying time, drying rate, drying efficiency and specific energy consumption were evaluated. The results showed that drying rate decreased with drying duration. A rising rate period was followed by a falling rate period and the overall drying process occurred in the falling rate period. Six mathematical models were used to fit the drying rates data of crashed cotton stalks, and Midilli et al. model was found the best prediction model by comparing R2, RMSE and χ2 values between experimental and predicted moisture ratios. With decrease in material load from 250 g to 50 g, effective moisture diffusivity increased from 2.8668×10-8 m2/s to 7.9817×10-8 m2/s. Results also indicated that drying efficiency and specific energy consumption significantly increased with the increase of the material load. Average drying efficiency and specific energy consumption varied in the range of 7.52%-19.78% and 12.49- 35.90 MJ/kg water, respectively. There were a lowest energy consumption of 10.99 MJ/kg water and a highest drying efficiency of 17.13% at the material load level of 250 g.
Keywords: mathematical modeling, crashed cotton stalks, man-made composite material, microwave drying, kinetics
DOI: 10.3965/j.ijabe.20160902.2190

Citation: Wang H T, Li P, Guo K Q. Mathematical modeling of microwave drying of crashed cotton stalks for man-made composite material. Int J Agric & Biol Eng, 2016; 9(2): 171-178.

Keywords


mathematical modeling, crashed cotton stalks, man-made composite material, microwave drying, kinetics

Full Text:

PDF

References


Panthapulakkal S, Sain M. Agro-residue reinforced high-density polyethylene composites: Fiber characterization and analysis of composite properties. Composites Part A: Applied Science and Manufacturing, 2007; 38(6): 1445– 1454.

Reddy N, Yang Y. Properties and potential applications of natural cellulose fibers from cornhusks. Green Chemistry, 2005; 7(4): 190.

Reddy N, Yang Y. Properties and potential applications of natural cellulose fibers from the bark of cotton stalks. Bioresource technology, 2009; 100(14): 3563–3569.

Qi C, Yadama V, Guo K, Wolcott M P. Thermal conductivity of sorghum and sorghum–thermoplastic composite panels. Industrial Crops and Products, 2013; 45: 455–460.

Qi C, Guo K, Liu Y. Preparation and properties of cotton stalk bundles and high-density polyethylene composites using hot-press molding. Journal of Reinforced Plastics and Composites, 2012; 31(15): 1017–1024.

Tamrakar S, Lopez-Anido RA. Water absorption of wood polypropylene composite sheet piles and its influence on mechanical properties. Construction and Building Materials, 2011; 25(10): 3977–3988.

Soysal Y, Öztekin S. PH—Postharvest Technology. Journal of Agricultural Engineering Research, 2001; 78(1): 57–63.

Femenia A, Sastre-Serrano G, Simal S, Garau MC, Eim VS, Rosselló C. Effects of air-drying temperature on the cell walls of kiwifruit processed at different stages of ripening. LWT - Food Science and Technology, 2009; 42(1): 106–112.

Dadalı G, Kılıç Apar D, Özbek B. Microwave Drying Kinetics of Okra. Drying Technology, 2007; 25(5): 917–924.

Özbek B, Dadali G. Thin-layer drying characteristics and modelling of mint leaves undergoing microwave treatment. Journal of Food Engineering, 2007; 83(4): 541–549.

Wang Z, Sun J, Liao X, et al. Mathematical modeling on hot air drying of thin layer apple pomace. Food Research International, 2007; 40(1): 39–46.

Sanjuan N, Lozano M, Garcia-Pascual P, Mulet A. Dehydration kinetics of red pepper (Capsicum annuum L var Jaranda). Journal of the Science of Food and Agriculture, 2003; 83(7): 697–701.

Sarimeseli A. Microwave drying characteristics of coriander (Coriandrum sativum L.) leaves. Energy Conversion and Management, 2011; 52(2): 1449–1453.

Bhattacharya M, Srivastav PP, Mishra HN. Thin-layer modeling of convective and microwave-convective drying of oyster mushroom (Pleurotus ostreatus), Journal of food science and technology, 2015; 52(4): 2013–2022.

Darvishi H, Khoshtaghaza M H, Najafi G, Nargesi F. Mathematical modeling of green pepper drying in microwave-convective dryer. Journal of Agricultural Science and Technology, 2013; 15(3): 457–465.

Soysal Y, Öztekin S, Eren Ö. Microwave Drying of Parsley: Modelling, Kinetics, and Energy Aspects. Biosystems Engineering, 2006; 93(4): 403–413.

Maskan M. Microwave/air and microwave finish drying of banana. Journal of Food Engineering, 2000, 44(2): 71–78.

Doymaz İ, İsmail O. Drying characteristics of sweet cherry. Food and Bioproducts Processing, 2011; 89(1): 31–38.

Jangam S V, Joshi V S, Mujumdar A S, Thorat B N. Studies on Dehydration of Sapota (Achras zapota). Drying Technology, 2008; 26(3): 369–377.

Darvishi H, Asl A R, Asghari A, Azadbakht M, Najafi G, Khodaei J. Study of the drying kinetics of pepper. Journal of the Saudi Society of Agricultural Sciences, 2014; 13(2): 130–138.

Mousa N, Farid M. Microwave Vacuum Drying of Banana Slices. Drying Technology, 2002; 20(10): 2055–2066.

Figiel A. Drying kinetics and quality of beetroots dehydrated by combination of convective and vacuum-microwave methods. Journal of Food Engineering, 2010; 98(4): 461–470.

Venkatesh M S, Raghavan G S V. An Overview of Microwave Processing and Dielectric Properties of Agri-food Materials. Biosystems Engineering, 2004; 88(1): 1–18.

Khratshen M A M, Cooper T J R, Magee T R A. Microwave and air drying I. Fundamental considerations and assumptions for the simplified thermal calculations of volumetric power absorption. Journal of Food Engineering, 1997; 33(1): 207.

Araszkiewicz M, Koziol A; Oskwarek A, Lupinski M. Microwave drying of Porous Materials. Drying Technology, 2004; 22(10): 2331–2341.




Copyright (c)



2023-2026 Copyright IJABE Editing and Publishing Office